Make sure both pulleys are in-line facing each other.Do this with caution to avoid deformation on the tabs. Place the pulleys in the right position and screw them properly with the right type of bolt.Drag the location of the pulley and ensure it rests at the end of each arc.Although this part is considered to be the longest part since the strength of the arc is solely dependent on it.Leave a space of 7 centimeters on both sides where the pulleys will be placed afterward.Progress by a little section of 14 -20 centimeters, make sure the torch is appropriately moved this will help the pipe from burning off completely.Soften the plastic by heating the pipe with a torch afterward, you can flatten the pipe to get the shape of a bow.Make sure the tee is placed right in the middle of the pipe you intend to use, then mark out the spot on both sides to help centralize the pipe once it is handled.First, insert a 32-diameter pipe in a 40-diameter tee.– Wood trunnion – 60 centimeter – diameter 8 millimeter: one by arrow – Five PVC collars – diameter 40 millimeters – Eight top-quality crossbow bolts with screws and ring – One “Y” PVC connection – diameter 40 millimeter – Three PVC bends 45° – diameter 40 millimeter – One PVC pipe – 1, 5 meter – diameter 40 millimeter – One PVC pipe – 1 meter – diameter 32 millimeter Step 1: Components and Tools Needed: Tools:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |